Control Multiple Actuators with One Controller
For the precise nanometer movement of actuators and other piezo products, an amplifier is required. Multi-channel amplifiers allow you to control multiple actuators or piezo products with a single amplifier. The NV40/3 piezo amplifier was designed for controlling low voltage piezo elements. It includes a voltage amplifier, a display and a PC-interface. The high-resolution display shows the voltage of the actuator, along with the mode of operation and the temperature inside the amplifier.
This amplifier also provides the opportunity to control the piezo element via analog modulation input or RS232. The actuator voltage can be viewed via the monitor output.
Due to the very low voltage noise of the output current, only 0.3 mV rms, the amplifier is ideally suited for positioning applications with sub-nm resolution. Special protective circuits prevent voltage spikes when switching the unit on and off and consequently avert any overload caused by overheating or short-circuiting. This soft-start ensures an actuator-safe activation of the system.
Due to its design and compact casing, the amplifier is recommendable for R&D and engineering applications.
Applications:
Typical configurations in university and industry settings: Laboratory applications, high resolution positioning, short rise time of low voltage actuators, and in wide variety industrial applications.
System Specifics:
- Dimmable TFT display
- 40 mA permanent output current per channel
- Low noise output signal
- USB 2.0 and RS232 interface
- Analog input and output signals
- Position control for strain gauge and capacitance sensors (CLE version)