In the catalog a resolution of e.g. 2 nm is specified. How can I check this resolution?

Upon customers' request, and because of the predetermined digit numbers, some of our amplifiers (e.g. NV 40/1 CLE) just display two digits after the comma. Thus, the amplifier can only display the motion of the system in 10 nm-steps. This doesn't mean that the actuators show a worse resolution than the value given in the catalog. It means that you can't see it on the display.

The monitor output must be used in order to check the accurate resolution. Over the MON-voltage and the sensivity (see calibration protocol) the exact motion, and hence the resolution, can be determined.

For more information, please contact our sales team.

+1 (508) 634-6688U.S. Office

+49 (3641)-6688 0German Office

Please contact our technical staff for further assistance. Together with you we will find a solution for your needs.

e-mail address:


contact sheet
By submitting I confirm the privacy notices in particular according to Art. 13 GDPR.
* This field must be filled!

We will get in touch with you as soon as possible.

partners worldwide